Search results

don't they only share the DCi engine as it's renault the CR and HR engines are nissan. it was posted before that NMUK put a 172 engine in a k12 for testing, didn't handle and sales for 2.0 litre micra were not worth the effort.... apparently....

it's been posted before, a few times lol. still top stuff ha ha

yup, they did. you never see many about though about 60 horses give or take iirc

like the 'might' comment leaving plenty time for you to bail out and get another k10 lol

don't most 1.0's do 0-60 between 12-20 seconds? and top out at 90-105mph? be a long race ha ha

if i can get my hols in at work i should be along in the 160 :) only a 4 1/2 hour drive lol :D

that's quite funky in a stange kinda way :D

lol was an oil leak last time it was posted ha ha

welcome back bud :D

the kit comes with rear corner splitters, the prev owner might not have had them fitted. look on ebay you'll the whole kit for £30, nissan would prob charge that a corner. then sell the bits you don't want. :)

:D have fun with it.

from what i remeber the L/LX was about 810/815kgs and the super s/sr was 835kgs, due to impact bars, air bags, bumpers/fogs/speakers etc. again i don't know if this figure was for a fully spec'd (pas/abs etc) super s/sr or the basic pack. all prefacelift numbers, the post 98 will more than...

195's fit in the arches fine with no scrubbing and are usually what people use. no problems even when lowered. (which is recommended with 15's, gets rid of the tractor look) best tyre for 15's would be 195/45/r15 this will fit fine and not cause a major headache with your speedo reading...

http://cgi.ebay.co.uk/nissan-micra-k12-HKS-coilovers_W0QQitemZ140173265133QQihZ004QQcategoryZ10402QQssPageNameZWDVWQQrdZ1QQcmdZViewItem riks ebay listing if its any help.

a few people have just used lowering springs that i'm aware, eibach, koni and tien spring to mind, no pun ment... generally give 30-40mm drop not sure on the rates though. i'm sure tien did a basic damper upgrade also. rik was using HKS coilovers which were recently put on ebay don't know the...

835kgs if i remember right.

no what i ment is they are fine for tootling about, don't get me wrong they are incredably pants for constant hard braking. if they were that unsafe they wouldn't have them fitted and they would have changed at one of the major face-lifts. the ga14/16 brakes are the best for the k11 and the...

the normal k11 brakes are fine for taking a standard k11 to sainsburys and back, ga14/16 are the best all round for increased performance. but flat out stopping power pulsar brakes all the way. in my opinion i think the pulsar set up is to heavy for a standard micra or even a janspeed micra...

its a breather pipe, you can either refit it to your new set up or leave it be.

welcome to the msc, :)