Search results

Is it true that the automatic micra engines come with a closed deck block? I have low milage automatic CGA3 in the shed as spare and can't be bothered taking it apart to check. I know the manual ones are open deck. That is a ****ed manual CGA3DE block which I have lying around. If indeed the...

Am I right to assume that the main difference between a cga3de and cg10de cylinder heads is the cams. I am looking to fix a spare cga head with bent valves I have a spare cg10de head for donor valves. Looking at a supply catalogue it gives the same part number for the cg10de cg13de cga3de inlet...

My car is currently at a local tuning garage getting mapped with a td04l turbo on a CGA3DE run by emerald k6 ecu. A map sensor was fitted car is making great power up to 5000rpm then starts to run rich not getting enough air the turbo is set 7psi and does make boost. I am guessing there is...

Just wondering has anyone fitted a half size civic radiator on a k11? They look like they will fit I know a lot of people put them in Toyota glanzas.

Does anyone have experience running a Haltech Sprint 500 on a CGA3DE engine. I know most people go for omex but my local tuner doesnt have experience with them. I have been told it should work no bother. The car will be getting turboed after the ecu is up and running.

I have a chance to get a nistuned ecu for my turbo build. My question is whether it is compatible direct plug and play on 2000 1.0 k11 coilpack car which has been engined swapped to a cga3de 1.4 The car runs fine with the 1.0 ecu. The 1.4 car which I got the engine from had a bosch ecu so I...

I am running 773 Rally Cams on my 1.4 coil pack Micra. I am having problems with the engine cutting out when approaching junctions etc.. at low speeds. I have turned up the idle on the throttle body couple of times but it is still doing it. Does anyone have any experience in overcoming this...

Managed to get a nissan consult diagnostic tool from china. Having problems with the software it installs fine but when I try to run it I get an error: NDA_Launcher.exe - Entry Point Not Found The procedure entry point GetFileVersionInfoA could not be located in the dynamic link library...

I am thinking of getting a Nistune board so I can get my engine remapped . Was wondering whether anyone has any experience with the boards and where you can get them in the UK.

Just a quick question will re-profiled cams from a 1.3 CG13DE fit in a 1.4 CGA3DE engine.

I have an instrument cluster with rev counter from 1.4 coilpack for sale. I am selling it because my k11 1.0L was hit from the back and has chassis damage and the insurance will be writing it off(so I have replaced the original cluster). Have put a deposit on 1.4 coil pack(as a replacement car)...