Search results

Just replaced my TB and still have the same problem as before. When warm, the car is basically undriveable. It idles fine and revs with no problem. Good spark. Injectors are ok... any suggestions? Have already put a lot into this thing and need to sort it soon.

as stated. I've lost the tiny spring the goes between the HT lead and the dizzy cap. I've spent an hour looking for it and would like any input as to what I can replace it with.

Wanting to change over to stainless allen screws, but can't seem to find my thread gauge or my calipers to measure accurately. Anyone know what to get?

http://nissan4u.com/parts/micra/el_k11e/1998_4/type_48/body_side_and_rear/front_door/illustration_3/ part nr 6 and 13 right side door linkage between the handle and latch including the bushing at the bottom...

Thinking of a trip over to the UK one of these days.. how much would one expect to pay for a full respray? Have a couple of small dents, one of the left front wing, right side door, and a couple of small dings on the roof. Also thinking of smoothing the roof rails and boot. Here they want over...

Purchased an apple green GX 1.0 with 188000 km in October 2011 Known issues and general condition at purchase: Some light rust behind the front right wheel arch, along the roofline of the boot, other various small patches Right side door slightly dented, left fender dented near headlight...

I have a 98 GX 1.0 that has been running poorly for some time now(lack of power, running too rich, and hesitating severely under acceleration) Today I had a look down the throttle body while holding the throttle wide open and saw a pool of petrol. I have never seen something like this on an...

I am urgently in need of a right side lower suspension arm for a 98 3dr k11. I have searched ebay for parts, but unfortunately I can't seem to find anyone willing to ship to Norway, or I can't contact the seller to get information about the parts. I don't see any point in paying £225 here for...

Thinking of doing a bit of tidying up in the engine bay and would like to do something with the rocker covers. What are your thoughts on doing covers?