.Maarten's latest activity

  • .Maarten
    .Maarten replied to the thread High idle. 2500rpm! Help!.
    Start with checking if the throttlecable is adjusted properly. If so check and clean the idle control stuff on the tb.
  • .Maarten
    .Maarten replied to the thread Door openers installed.
    You cant. You need the remote and module that came with the set.
  • .Maarten
    .Maarten commented on Seb_'s profile post.
    Its Step 2: Use the plastic fork to gently pull of the needles. Thats before the back cover even comes off. Im not sure its even...
  • .Maarten
    .Maarten commented on Seb_'s profile post.
    Yes the needle are pushed on from the front. But from factory they are hard to remove as they are pushed on tight.
  • .Maarten
    .Maarten commented on Seb_'s profile post.
    Where does it go wrong? As the needles are just push fit
  • .Maarten
    .Maarten replied to the thread Loom removal.
    To the fusebox in the cabin. It has all the stuff in it that the engine loom doesn’t have
  • .Maarten
    .Maarten replied to the thread Loom removal.
    Goes to the fusebox next to the battery
  • .Maarten
    .Maarten replied to the thread Thottle body help.
    Wont bolt on but can be made to fit. But will need welding. And needs mapping but ideally a stand alone ecu
  • .Maarten
    .Maarten replied to the thread Thottle body help.
    No wont fit. Different bolt pattern en different sensors.
  • .Maarten
    .Maarten replied to the thread coil pack engine or distributor engine ?.
    Do you have 4 leads on the top off the engine that go to a round think on the side of the engine? Or do you have 4 black square boxes on...
  • .Maarten
    .Maarten replied to the thread K11 Loss of Power.
    That error is for the clutch solenoid. Might be dirty or low transmission fluid or some water in the connector
  • .Maarten
    .Maarten replied to the thread I have a k11 import which i want to convert to electric can anyone tell me where to get the parts.
    Internet. As far as I know there are no plug and play kits so you have to make a lot yourself. If you don’t even know how to find parts...
  • .Maarten
    .Maarten replied to the thread key fob not working.
    So they flash when it needs to program the fob? NOt only to indicate programming mode? Ive attached the programming instructions. The...
    • ab inleren.JPG
  • .Maarten
    .Maarten replied to the thread key fob not working.
    Can you enter programming mode? If so the module is likely good. If you enter programming mode and the blinkers wont flash when...
  • .Maarten
    .Maarten replied to the thread New Throttle Body.
    You can find the Datascan manual here: https://www.nisscan.com/NDSI/download/Nissan_Datascan_User_Manual_1.0.pdf
Show older items
Top