Recent content by LordJunk

  1. L

    Warning lights weird sound

    just hold the electric meter to the battery contacts. in PARALLEL! Not Series. do NOT disconnect plugs form alternator.
  2. L

    Convert K11 to Electric EV. Mad or Worth a Go?

    or just try driving with your starter 😜 Sure an electric K11 would be interesting. But i'd rather be interested in bolt on hybrid technology. Maybe one of those Starter/Atlernator combos And an electirc Supercharger/Turbo... using recuperation and so on.
  3. L

    Warning lights weird sound

    measure the voltage while engine is running to check if the alternator is ok. Engine on without any other electrics should be ~14V and get lower with every electric device you turn on, but should always stay above 12V
  4. L

    How to start changing Drive Belt?

    what kind of sound do you hear? Do you have powersteering? If you want to change the Belt it's the safest bet to take the same, as the one you already have.
  5. L

    K11 can they take E10 petrol?

    obvously nissan is on the defense on a sensitive topic like this. Like: if you put in E10 and your car breaks, they don't want to be held responsible.
  6. L

    CG10 finetuning advice (Cams, Headers, Injectors, ECU?)

    it was the 2nd notch more or less. not perfectly as it depends on the angle you look etc...
  7. L

    CG10 finetuning advice (Cams, Headers, Injectors, ECU?)

    tried to check the lobes... it's actually really hard to tell by looking at the lobes. Checking the timing marks is easier and it's set right: the lobes: The exhaust sound: the coughing is hearable, though it's a very low tone and my mobiles Camera/Mic isn't suited ideally for the job...
  8. L

    CG10 finetuning advice (Cams, Headers, Injectors, ECU?)

    yes, definitely. Measured they have about 1,5mm more lift. They must be the 1.3 Cams. The engine has ~170k km (~100k miles), always starts without hesitation, even with the old battery and starter. never measured compression tho... whatever i can think of, you already tried :D👍
  9. L

    CG10 finetuning advice (Cams, Headers, Injectors, ECU?)

    is that the reason the car might feel slower once the engine is hot as well? Open loop on cold engine? It feels snappier when it's cold. But of course the idle speed while it's cold is higher too. Could be a dirty mod to put in a switch that shows the ecu a colder temperature value 😅 should...
  10. L

    Micra K11 seats??

    thanks:(
  11. L

    CG10 finetuning advice (Cams, Headers, Injectors, ECU?)

    The car is well maintained. timing was at raoundabout ~15° btdc. I tried different setting prior changing cams and the Exhaust manifold, and it felt like it would accelerate faster, but behave much worse if it goes uphill or if the car is loaded. The chain is not worn. i chainged it a few years...
  12. L

    definitive fix for a red chip key nats k11 micra (cg10or cg13 engine) with nats / immobiliser problems.

    But at least there is the key ring reader... but i guess it won't be harmed. The red NATS light in the center console is working as usual as well: blinking while turned off, and stops blinking when the enigne is running 👍
  13. L

    Micra K11 seats??

    could somebody move this from build diaries/Blogs to mechanical or wherever fits? I'd be interessted in other seats as well, preferably plug/play (or more like screw and sit 😅 ) No other nissans to chose from? Somethign that is lower for taller people?
  14. L

    CG10 finetuning advice (Cams, Headers, Injectors, ECU?)

    Hello Micramaniacs, I have mine since 2017 and started to like it more and more the longer i have it. Not as a sportscar but as a small extraordinary comfortable (and reliable) car (especially for its size) that you can rev to the limit every now and then without worrying. it's a preFL 1.0 from...
Top