Recent content by gabriel_herlihy

ಥ‿ಥ チャット中のF ಥ‿ಥ Sent from my SM-G930F using Tapatalk

https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.co.uk%2Fulk%2Fitm%2F254172116772 Good quality too Edit: didn't see reply Sent from my SM-G930F using Tapatalk

You won't be able to buy that, it's a photoshopped R34 front bumper and what I assume is the front wings from a GT-R R34 front and back. It would be both expensive and time consuming to make it work, but could be done. Sent from my SM-G930F using Tapatalk

I don't know how the boot button is set up either. But removing the plastic trim might totally render it useless? You can use square plates with the trim kept on. You just need to lower and tilt it a bit on the back Sent from my SM-G930F using Tapatalk

I've never done it, neither am I planing too. But I think it'll leave a couple holes where the clips for the plastic went into. Easily filled in. Or alternatively buy a march (JDM) spec boot Sent from my SM-G930F using Tapatalk

Last time I checked, and this is a rough guess as to what I read. NO tread should be seen past the fender/quarter panel line. I'm not sure about stretch though Sent from my SM-G930F using Tapatalk

No, all Micra engines are twin cam. It simply means that there is a cam for the intake and exhaust. Sent from my SM-G930F using Tapatalk

You have a few? How much you willing to flog one off for? Sent from my SM-G930F using Tapatalk

I know you can install aftermarket counters or both coilpack non coil pack Micras, BUT when looking for rev counters I see items like pictured. Are these genuine? I own an non coil pack 2000 reg micra, would I be compatible with them? Thank you [emoji16] Sent from my SM-G930F using Micra Sports...

What engine is in the car? I'm looking for a 1.0l exhaust for my 2000 Micra Sent from my SM-G930F using Tapatalk

So I have a 1.0l 16v Micra, with a mighty 60hp! Enough of the bragging, I'm looking to install an aftermarket air filter. One to reduce the amount of debris that flies into the stock one, which is mad amount. And two to spruce up my engine bay a bit! BUT, when removing the stock one there was a...

I am a student doing level 3 engineering, so the car is a great way to expand my knowledge ;) Sent from my SM-G930F using Micra Sports Club mobile app

Thank you very much, I will be going ahead with it soon :) Sent from my SM-G930F using Tapatalk

So in an effort to customise and make my Micra unique, I am opting for the smoothed bumper look! All the small body lines in it and black inserts are absolutely absurd! What type of body filler would I use to fill the small bumps and crevices? Help much appreciated [emoji2] Sent from my...

You are correct in assuming it is a 4x100 pattern. If unsure look at the specs on the internet Sent from my SM-G930F using Tapatalk