Recent content by cherrytuner

Awesome build, keep it going :)

Hey I need good original injectors to a K11 1.3 , maybe up to three sets if you give a good offer on them all ;) And only offer if you can post to Finland. Also fuel pumps in good working order needed. Thanks!

Hmm thanks for the tip...must check this when i get the front end fixed from the blackmask...hopefully next weekend!

It´s not good for the gearbox if you drive at 30mph in 5th gear.....these K11 and other nissan gearboxes are "famous" of lubrication issues (main bearings failing/5th gear not keeping in/etc) and overfilling is not a bad option. And if the gearbox has bearing issues then the fuel consumption...

You can choose , or take both out. Will need one in MOT anyway.

Inside the maf, there are topics which explain the whole repair thing with pictures.

Same size as the old ones. If not sure about the threads, then try different kinds of bolts until you find fitting ones. You can always measure the threads from the old ones with a proper tool if there is even a bit of thread left at those.

Castrol magnatec has been good in my motors , been using it recently.

The timing is not the issue then....that haynes number should be close enough :) Souds a lot like related to the tb joints...as karlj said. Easy fix!

With that long being not serviced you should change at least these: -Air filter -fuel filter -spark plugs Also cleaning the maf wire and re-soldering the throttle body should be done.... New fuel pump would be next to check if those jobbies dont help :)

Should check the plugs/fuel filter/distributor/ignition timing also... I recently bought a K11 for spares and was lacking power, ignition timing was way late... after adjusting was all good again.

The 1.0 should surely go up a hill faster than 15mph?

Has the car been serviced? The power problem could be also related to fuel pump.

Why do you have to go and touch them? I don´t understand.... The car works just as well without the heat shields which are in the exhaust.

The only reasonable option is to swap to 1.3 engine, and it is easy to do by yourself. We´ll help you if you run into some problems ;)