Creaking after lowering

Hi all, so yesterday I installed the HR 50mm springs for my 160, now I'm getting a creaking on the NSR, now I automatically fitted the bump stops to the rears, now I'm not sure whether that was right or not, anyone have any ideas?

Cheers Kai
 
Its passenger side rear. Near side, closest to kerb, rear.

check the springs are sat in the cups correctly. Check shocks, you might have one wearing more than the other and the springs have exposed this. Have a good look at any bushes as again the shift in geometry might be putting a bit extra strain on a wearing part
 
Its passenger side rear. Near side, closest to kerb, rear.

check the springs are sat in the cups correctly. Check shocks, you might have one wearing more than the other and the springs have exposed this. Have a good look at any bushes as again the shift in geometry might be putting a bit extra strain on a wearing part
Thank you, will check all of these, pretty sure the springs were sat correctly, sounds like the noise is coming from the top of the rear shocks, 4 up earlier and it was both sides.
 
Back
Top