Nissan Be-1 owner.

[DanieltheSpaniel]

Hi everyone (I know I've posted this in the Nissan be-1 section) but that was almost 3 weeks ago, I've had no luck so I thought I'd post it here.


I recently imported a Nissan Be-1 from Japan. The main problem is that it's fairly rusty. It's in need of new floor pans and inner/outer sills.

I know that the Mica K10 shares quite a few of the same parts.

I've checked the part numbers on amayama and I can source most of them, however the outer sills are a problem.

So my question(s) would be;

Do I import the original parts from Japan.?
Do I source parts here in the UK from a K10.?
Or do I have new parts made here in the UK.?

I think I either need to hear that it's a waste of time/money. Or I should just go ahead with it.

Any help or advice would be much appreciated.

Kind regards
Daniel.

 

[Tommysmicra44]

Hi everyone (I know I've posted this in the Nissan be-1 section) but that was almost 3 weeks ago, I've had no luck so I thought I'd post it here.


I recently imported a Nissan Be-1 from Japan. The main problem is that it's fairly rusty. It's in need of new floor pans and inner/outer sills.

I know that the Mica K10 shares quite a few of the same parts.

I've checked the part numbers on amayama and I can source most of them, however the outer sills are a problem.

So my question(s) would be;

Do I import the original parts from Japan.?
Do I source parts here in the UK from a K10.?
Or do I have new parts made here in the UK.?

I think I either need to hear that it's a waste of time/money. Or I should just go ahead with it.

Any help or advice would be much appreciated.

Kind regards
Daniel.

Get the parts from japan or sell before it breaks your heart

Cause if not done restoration correctly ur just gonna have problems all over again it the near future