Recent content by rasta

Hello and thanks for the replys! Fuzzy-hair-man I never even thought of that. So you had the splines cut into the outer end of the shaft after turning it down? Where did you get that done? There are a few machine shops near my work and a CPS that we have an account with, I was going to ring...

No, I'm not reusing the old ones. They were just for testing purposes really. They are half Primera half Micra. I want to make or get some Primera shafts made up because they are bigger and I was planning to go turbo in the future. The micra side of the shaft is quite small campaired to the...

Hello and thanks for reply. Basically I want to get a hub face that is PCD 4x100 that will take an SR20DE driveshaft so I can get it turned down on a lathe and then press it into the Micra wheel bearing. I was curious if GA16DE engined cars had the same number and size splines on the outer part...

Hello everyone I'm currently upgrading the driveline on my SR20 Micra. Can anyone tell me if the GA16DE C.V Joints are the same as the SR20DE? I need front hubs that are the same as the Almera Gti ones because I'm finding it hard finding scrap ones. Cheers

Ok so I downloaded the wiring diagrams for the micra which are mint! So much detail, is there anything like this for the Primera? Anyway I metered out all the wiring for the immobiliser and everything was right. I done all the checks in the manual and everything is there. I even mounted the...

Sounds good mate I will try and get it sorted tomorrow if not I will buy that off you straight away. Cheers

Thanks frank I will start reading through that. That sounds like a fair price for the ecu. Is it from an old car without nats or has it been decoded or something? Would I need to swap some wiring about? Cheers thanks for help.

Happiness! I like he sound of that frank could you point me I the right direction for the nats .pdf? Also how much would you be looking for, for your ecu? Cheers thanks for help

Yes I think your right. this is the place I'm going to be looking tomorrow. I have one wire coming from the Ecu that goes to the immobiliser. My wiring diagram says its pin26 on the ecu and I have this going to pin 1 of the immobilser so I need to check this is right. Is anyone familiar with the...

Are non nats ECU's hard to come by if I cant get the immobiliser sorted? Cheers

Update, it's a NATS fault :(. After going over and metering out the wiring a million times and finding no faults I decided to plug nats back in to see what happens and it does the exact same thing injector pulse, fuel pump primes and I have spark etc. Tried the Primera key in the reader and the...

Ok so today I connected the resistor back on the coil then switched the ignition on. Randomly the engine light wasn't flashing like it always is (does the same on other Micra that works). I started it and it fired up instantly on the button and I revved it straight to the limiter for the first...

Ok so here's the crack, I finally found a Micra that wasn't rotten so I put an sr20de in it from a 98 Primera GT. I'm running half Primera half Micra loom. Using the multi plugs from the Micra engine loom and Primera interior loom I made an adapter loom that just plugs in to combine the two...

Yea polly I've heard they are not very reliable, i can rebuild them of need be like. Cheers

Oh nasty.... Not one the trucks I've done like ha ha