Recent content by AntiNissan

  1. A

    Cvt oil level

    If you're looking to DIY, pic of instructions attached ;-) However, for a better drain and fill, I removed the transmission sump as you get more of the old oil out, can clean out the sump, remove and clean/replace the basic metal filter in the sump, and replace the small paper cartridge type...
  2. A

    Water in boot/wheel well?

    Has anyone had a problem / leak where some water gathers in the wheel well in the boot? Our's is leaking a bit e.g. after rainfall, it seems to getting in from the near/left hand /passenger side (in the UK), after taking the carpet and trim off in the left hand side, found a potential area in a...
  3. A

    London Ultra Low Emissions Zone ULEZ

    Nope it isnt, it's favouring the rich and spendy - buy a new car and or keep your classic, but then those living in London should mass protest against Mr Khan (do what I like) and the deal he had with the government over ULEZ. You'd think paying your Road * Fuel taxes shgould be enough to let...
  4. A

    Rear hub nut torque setting

    209nm / 154 lbft
  5. A

    Oil engine change

    Any good brand, Castrol Edge, Mobil 1, Motul x8100 amongst others 4L will be all you'll need. Check on line for good prices. Easy job to change oil and filter.
  6. A

    DIG-S HR12DDR micra fault code solution P0014, P0300

    Yep UK rip off. And UK brexit stupidity, On the plus side I ended up getting the vvt solenoid from https://www.nengun.com/ cost all od £114 delivered. I got a spare one in 2021 from same place £89 delivered. SAve your UK money and buy from Japan. Crazy world of caveat emptor.
  7. A

    Cvt oil level

    Yes. car level anv cvt oil < 45c, behind the drain plug there is a small pipe - best described as an overflow pipe (which has to be removed if drainig/doing a partial oil change*), you put enough oil in via this until the oil no longer runs out, this is with the engine running and after you have...
  8. A

    K13 front drivers side headlight assembly removal

    It's a bumper off job :-( Wheel arch liner removal, or at least the front to allow access to the fixings from the wings to the front bumper, and the lower/under bumper panels- rather a pita I'm afraid, you need to do this to get a headlamp bolt on the bottom of it that's not accessible from...
  9. A

    Alloys

    I think you'll find all k13 micra wheels are swapable without issue. Also the standard e12 Note 15" alloys fit, and they are a little bit wider - with no issues - I use the wider ones for summer use, and the original Micra 15" ones with winter tyres (165/65/15). IMO the Note ones being slightly...
  10. A

    DIG-S belt drive noise

    All too true - on teh squeaking belts my local nisan dealer said 'they all do that', which has turned out to be *******. I changed the belts (did both as is a dig-s at the same time) for Gates ones and no more squaeking :-). I did chcek the main tensioner and the wheel/bearing did not feel...
Back
Top